Contrinex pressure resistant inductives give concrete advantages

Manufacturers of mobile concrete pumping trucks trust Contrinex’s High-Pressure sensors to monitor the piston position in the hydraulic drive cylinder. These sensors provide exceptional reliability despite the challenges of pressure cycles and high-pressure peaks, increasing longevity and efficiency and reducing maintenance costs for these concrete pump. An additional benefit is that these sensors are part of Contrinex’s Extra Distance family and so combine long operating distances despite the pressure-resistant housing.

Customer application

Concrete pumps use a double-piston pump and require two feed cylinders that pump concrete at a working pressure of up to 400 bar (5800 psi). These feed cylinders are driven by pairs of hydraulic cylinder pairs which operate in push-pull opposition. To achieve the maximum possible efficiency, the timing of this push-pull operation must be precisely coordinated. It is therefore essential to monitor the cylinder limit position with sensors that are resistant to high pressure.

The dynamic stresses on all components built into the hydraulic system are very high, due to constantly changing pressure cycles during pump operation.

Concrete pump failures are extremely costly because they can cause construction problems and stoppages and risk compromising the building being constructed. If the breakdown is due to problems in the hydraulic system, all the hydraulic oil must be drained to correct the fault. Then, after refilling and before start-up, several time-consuming de-aeration cycles must take place before the pump is fully fit for service again. This prolongs the construction stoppage.

The customer’s requirements for longevity and resistance to high peak pressures are essential to guarantee the smooth operation of such systems.

Customer solution

Contrinex High-Pressure sensors (series 500P) withstand the necessary pressure levels (peak pressure up to 1000 bar – 14500 psi) due to a patented process whereby a solid ceramic disk is built into the stainless steel housing.

These sensors are fully resistant to dynamic stresses. Patented technology ensures that all electronics, including the ferrite core and coil, are located on the unpressurised side of the housing. This results in an unusually long life under pressure cycle stresses.

To monitor cylinder limit positions in the concrete pump, two sensors are installed and connected to the control system. Due to their longevity, which is ten times greater than the market standard, maintenance costs are reduced to a minimum.

Contrinex sensors are available from PLUS Automation: www.PLUSAx.co.uk

Check Also

Analog Devices announces nanopower primary cell State-of-Health monitor with precision coulomb counter

Analog Devices, Inc. has introduced the LTC3337, a nanopower primary (non-rechargeable) cell State-of-Health (SoH) monitor …

Renishaw sponsors Greenpower electric car race

Global engineering company, Renishaw, has announced that it has renewed its longstanding sponsorship of Greenpower, …